Physical Stats
Form Factor
Proprietary
Dimensions
16.64" x 7.71 " (42.26cm x 19.581cm)
Processor/Cache
CPU
Dual 1366-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
Intel® Xeon®Processor 5600 Series (Westmere)
Intel® Xeon®Processor 5500 Series (Nehalem-EP)
QPI
up to 6.4 GT/s
System Memory
Memory Capacity
12x 240-pin DIMM slots
Supports up to 192 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
Memory Mirroring supported
Memory Type
1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
DIMM Sizes
1GB, 2GB, 4GB , 8GB , 16GB
Memory Voltage
1.5 V / 1.35V
Error Detection
Corrects single-bit errors
Detects double-bit errors (using ECC memory)
Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
On-Board Devices
Chipset
Intel® 5520 (Tylersburg) chipset
ICH10R + IOH-36D
SATA
Intel ICH10R SATA 3.0Gbps Controller
RAID 0, 1, 5, 10 support (Windows)
RAID 0, 1, 10 support (Linux)
IPMI
Support for Intelligent Platform Management Interface v.2.0
IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
Winbond® WPCM450 BMC
Network Controllers
2x Intel® 82576 Gigabit Ethernet Controllers
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
1x Realtek RTL8201N PHY (dedicated IPMI)
Graphics
Matrox G200eW 16MB DDR2
Super I/O
Winbond 83827HG chip
Input / Output
Serial ATA
Six Serial ATA ports
Six SATA hard drives supported
LAN
2x RJ45 LAN ports
1x RJ45 Dedicated IPMI LAN port
USB
2x USB rear ports
2x USB internal headers
Total 4 USB 2.0 Compliant
VGA
1x VGA Port
Serial Port
1x Serial Port
|
|
Chassis ( Optimized for X8DTG-DF )
1U Chassis
CSE-118G-1400B
CSE-818G-1400B
Important Chassis Notes
To support the new generation Intel® Xeon® processor-based motherboards,
a Revision K chassis is recommended for most models.
Expansion Slots
PCI-Express
(w/ risers)
2 (x16) PCI-E 2.0 or 4 (x8) PCI-E 2.0
1 (x4) PCI-E 2.0 slot
System BIOS
BIOS Type
32Mb SPI Flash EEPROM with AMI® BIOS
BIOS Features
Plug and Play (PnP)
PCI 2.2
ACPI up to 3.0
USB Keyboard support
Management
Software
IPMI (Intelligent Platform Management Interface) v1.5 / 2.0
with KVM support SuperDoctor® III
Power Configurations
ACPI / ACPM Power Management
PC Health Monitoring
Voltage
Monitors for CPU Cores, +1.8V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby,
VBAT, Memory, Chipset Voltages.
6-Phase-switching voltage regulator with auto-sense from 0.8375V-1.60V
FAN
Total of eight fan headers supporting up to 8 fans
Eight 4-pin fan headers
8x fans with tachometer status monitoring
Support 3-pin fans (w/o speed control)
Low noise fan speed control
Temperature
Monitoring for CPU and chassis environment
Thermal Control for 8x fan connectors
PECI
Other Features
Chassis intrusion detection
Chassis intrusion header
Operating Environment
Environmental Spec.
Operating Temperature: 10° to 35° C (50° to 95°F)
Non-operating Temperature: -40° to 70° C (-40° to 158° F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing)
|