Que recherchez-vous ?
MBD-P4SCT+
Zoom

Marques

Format Carte Mère

MBD-P4SCT+

Référence - oicp-mbd-p4sct+
Note moyenne : 0 avis
329.00 € HT
Quantité 
+
-
Garantie :   Garantie : 1 an

Carte Mère ATX supporte Intel Pentium 4 3.4GHz max & Celeron 2.8GHz max (mPGA478), jusqu'à 4GB DDR, 2 Intel Gbe LAN, Dual IDE channels, 6 SATA, 3 PCI-X, 2 PCI, 4 USB, VGA

Demander un devis

MBD-P4SCT+
Notes et avis

Fonctionnalités


1. Intel® Pentium® 4 Support up to 3.4 GHz, Celeron® up to 2.8 GHz
2. Intel® E7210 (Canterwood ES) Chipset
3. Up to 4GB DDR 400/333/266 SDRAM
4. 1 x Intel® 82547GI CSA, 1 x Intel® 82541 Gigabit Ethernet Controller
5. Intel® 6300ESB Serial ATA Controller
6. Adaptec® Serial ATA Controller
7. 3 x 64-bit 66MHz PCI-X (3.3V), 2 x 32-bit 33MHz PCI (5V) slots
8. ATI RageXL 8MB PCI Graphic Controller

Description du produit


Physical Stats
Form Factor ATX
Dimensions 12" x 9.5", (30,5cm x 24.1cm)
 
Processor/Cache
CPU
Single mPGA478 ZIF Sockets
Supports an Intel® Pentium® 4 processor with 2MB of integrated Advanced Transfer Cache up to 3.4GHz (Extreme Edition)
Supports an Intel® Celeron® processor with 128KB of integrated Advanced Transfer Cache up to 2.8GHz
Hyper-threading enabled
 
System Bus 800 / 533 / 400MHz system bus
 
System Memory
Memory Capacity
Four 184-pin DIMM sockets
Supports up to 4 GB of DDR400/333/266 memory
Dual channel memory bus supported
Memory must be populated in pairs for dual channel interface
 
Memory Type
DDR400/333/266 (ECC or non-ECC) unbuffered SDRAM, 184-pin gold-plated DIMMs
 
DIMM Sizes
128MB, 256 MB, 512 MB, 1 GB
 
Memory Voltage 2.5 V only
 
On-Board Devices
Chipset
 Intel® E7210 (Canterwood ES) chipset
MCH + 6300ESB + FWH
 
Serial ATA
SATA Controller on-chip (Intel® 6300ESB)  (2x Drive support)
Adaptec AIC-8110: Marvell® 88SX5041 4-port Hercules-1, rev C0, SATA Controller (4x Drive support)
Six Serial ATA ports
RAID 0, 1, 10 Supported (for 4 HDD)
RAID 0, 1 Supported (for 2 HDD)
 
SATA Zero-Channel RAID
Support for Zero-Channel RAID with Adaptec 2020SAH1 (SATA) ZCR Card: 1A, 3.3V, Low Profile 2.5" x 6.6", 400MHz I/O processor, 64MB ECC DDR memory on board
[Card not included]
RAID 0, 1, 5, JBOD
 
Network Controllers
1x Intel® 82547GI CSA Gigabit Ethernet Controller
1x Intel® 82541 Gigabit Ethernet Controller
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
 
Graphics ATI Rage XL SVGA PCI video controller with 8MB of video memory
 
Input / Output
PCI Expansion
3x 64-bit 66MHz PCI-X (3.3V) slots
2x 32-bit 33MHz PCI (5V) slots
 
IDE Dual EIDE channels support up to four UDMA IDE devices
Supports UDMA Mode 5, PIO Mode 4, and ATA/100
 
Floppy
1x Floppy controller; 1.44 MB, 2.88 MB, 3-mode support
 
USB
2x USB 2.0 / 1.1 ports
1x USB header supports additional 2x USB 2.0 / 1.1 ports)
 
Serial Ports
2x Fast UART 16550 serial ports
 
VGA Port
1x VGA Port
 
Parallel Port
1x ECP / EEP Parallel Port
 
LAN Port
2x RJ45 Ports
 
Keyboard / Mouse
PS/2 keyboard and mouse ports
 
Chassis ( Optimized for P4SCT+ )
1U Chassis
SC813MT-300C
SC811T-250
 
2U Chassis
SC822T-550LP
 
Important Note To ensure system stability, a 300W (minimum) ATX power supply
[4-pin +12V AND (20 or 24-pin)] is required.
 
System BIOS
Bios Type
4Mb Flash EEPROM with AwardBIOS®
 
BIOS Features
Plug and Play (PnP)
APM 1.2
DMI 2.3 support
PCI 2.3
ACPI 1.0
BIOS rescue hot keys
Hardware BIOS virus protection
USB Keyboard support
 
Management
Software
SuperDoctor® III
Watch Dog
 
Power Configurations
ACPI/APM Power Management
Main Switch Override Mechanism
Wake-On-Ring (WOR) header
Wake-On-LAN (WOL) header
Power-on mode control for AC power loss recovery
Internal/External modem remote ring-on
 
PC Health Monitoring
Voltage
Monitors for CPU Cores, +3.3V, +5, ±12V, +3.3V/+5V Standby, VBAT
CPU Core 3-Phase-switching voltage regulator with auto-sense from 0.85V-1.65V
Adjustable CPU clock frequency ratio settings (via BIOS)
 
FAN
Total of five 3-pin fan headers
3x fans with tachometer monitoring
Status monitor with firmware/software on/off control
 
Temperature
Monitoring for CPU, chassis, environment
CPU thermal trip support
 
LED
CPU Overheat LED
System Overheat LED
+5V standby alert LED
Suspend-state indicator LED
 
Other Features
Chassis intrusion detection
Chassis intrusion header
 

Retour en haut
MBD-P4SCT+
Notes et avis

Avis des internautes sur MBD-P4SCT+ (0 avis)

pixel_trans
Il n'y a actuellement aucun avis pour cet article, soyez le premier à donner le votre.
pixel_trans
pixel_trans
[Ajouter votre commentaire]
Retour en haut