|
Physical Stats
Form Factor ATX
Dimensions 12" x 9.6 ", (30.48cm x 24.38 cm)
Processor/Cache
CPU Single LGA775 ZIF Socket
Supports Quad-Core Intel® Xeon® X3300/X3200 series
Supports Dual-Core Intel® Xeon® E3100/3000 series
Supports Intel® Xeon® processor L3360 and L3110 series
Supports Intel® Core™2 Quad Q9000/Q8000/Q6000 series
Supports Intel® Core™2 Duo E8000/E7000/E6000/E4000 series
Supports Intel® Pentium® E5000/E2000 series
Supports Intel® Celeron® E1000 and 400 series
NOTE: Intel Xeon processor L3014 requires an LGA771 socket and is not supported.
System Bus 1333 / 1066 / 800 MHz system bus
System Memory
Memory Capacity
Four 240-pin DIMM sockets
Supports up to 8 GB of memory (Dual Channel)
Memory Type
DDR2 800/667MHz unbuffered ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs
DIMM Sizes 256 MB, 512 MB, 1 GB, 2GB
Memory Voltage 1.8V only
On-Board Devices
Chipset
Intel 3210 chipset
ICH9 +2x Intel® 82574L + Broadcom 1068E
SAS
Broadcom SAS1068E
RAID 0, 1, 10 support
(Optional: AOC-IButton68) RAID 5 support
Serial ATA
Intel® ICH9 SATA2 (3 Gbps) controller built-in
Network Controllers
2x Single-port Gigabit PCI-Express Ethernet Controllers
Intel® 82574L
Supports 10BASE-T, 100BASE-T, 1000BASE-T, RJ45 output
1x Realtek RTL8201N PHY (dedicated IPMI)
VGA
Matrox G200eW 8 MB DDR2
Super I/O
Winbond 83627DHG chip
Clock Generator
CK505
Input / Output
SAS
8 SAS / SATA ports
Serial ATA
Two Serial ATA ports (3 Gbps performance)
Two SATA hard drives supported
Floppy
1 Floppy controller; 1.44 MB
LAN
2x RJ45 LAN ports
USB
Up to 8x USB 2.0 / 1.1 compliant ports
2 rear ports, 2 internal headers + 2 on-board
VGA
1x VGA port
Keyboard / Mouse
PS/2 keyboard and mouse ports
Serial Ports
1x Fast UART 16550 serial port
1x internal header
|
|
Chassis ( Optimized for X7SB3 )
1U Chassis
CSE-811T-260
CSE-811TQ-280
CSE-813MT-300C
CSE-813MTQ-280C
Expansion Slots
PCI-Express 1 (x8) PCI-e slot
PCI 1 32 bit PCI slot
System BIOS
BIOS Type
16Mb Flash EEPROM with Phoenix BIOS®
BIOS Features
Plug and Play (PnP)
DMI 2.3 support
PCI 2.2
ACPI 1.0/2.0
SMBIOS 2.3
USB Keyboard support
Management
Software
SuperDoctor® III
Watch Dog
NMI
W83627DHG(PECI support)
Power Configurations
ACPI Power Management
Main Switch Override Mechanism
Wake-On-Ring (WOR) header
Wake-On-LAN (WOL) header
Keyboard Wakeup from Soft-Off
Power-on mode control for AC power loss recovery
Internal/External modem remote ring-on
Suspend to RAM(STR)
PC Health Monitoring
Voltage
Monitors for CPU Cores ( +1.8V, +3.3V, +5, ±12V, +3.3V Standby,
+5V Standby, VBAT, HT, Memory, Chipset)
CPU Core 4-Phase-switching voltage regulator with auto-sense
from 0.3750V-1.6000V
Adjustable CPU clock frequency ratio (only available when CPU is supported)
FAN
Total of five 4-pin fan headers
5x fans with tachometer monitoring
Status monitor with firmware / software speed control
Status monitor for on/off control
Support 3-pin and 4-pin Fan speed control
Low noise fan speed control
Pulse Width Modulated (PWM) fan connector
Temperature
Monitoring for CPU and chassis environment
CPU Thermal Trip support
Thermal Monitor (TM2) Support
PECI
LED
CPU / System Overheat LED
+5 Standby alert LED
Other Features
Chassis intrusion detection
Chassis intrusion header
Operating Environment
Operating Temperature: 10°to 35°C (50°to 95°F)
Non-operating Temperature: -40°to 70°C (-40°to 158°F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
