Que recherchez-vous ?

MBD-X8DTU-6F+

Référence - oicp-mbd-x8dtu-6f+
Note moyenne : 0 avis
979.00 € HT
Quantité 
+
-
Garantie :   Garantie : 1 an

Carte Mère format propiétaire Dual Socket (LGA 1366) pour processeurs Intel® Xeon® 5600/5500 serie, jusqu'à 288GB ECC DDR3, 2 Gbe LAN, 8x6Gb/s SAS/SATA, 6 SATA2, IPMI/ RJ45 LAN dédié , 6 USB 2.0

Ajouter au panier

Demander un devis

MBD-X8DTU-6F+
Notes et avis

Fonctionnalités


1. Intel® Xeon® processor 5600/5500 series, with QPI up to 6.4 GT/s
2. Intel® 5520 (Tylersburg) Chipset
3. Up to 288GB DDR3 1333/ 1066/ 800MHz ECC Registered DIMM /48GB Unbuffered DIMM
4. Intel® 82576 Dual-Port Gigabit Ethernet Controller
5. Broadcom 2108 8-Port 6Gb/s SAS Hardware RAID Controller;  RAID 0, 1, 5, 6, 10, 50, 60
6. 6x SATA2 (3 Gbps) Ports via ICH10R Controller
7. Left Side 
     1 (x16) PCI-E 2.0 by riser card
    Right Side 
     1 (x4) PCI-E 2.0 by riser card (in x16 slot)
    For 2U configuration, Please go to
    UIO Riser Cards page
8. Integrated Matrox G200eW Graphics
9. Integrated IPMI 2.0 with Dedicated LAN
 
 

Description du produit


Physical Stats
Form Factor
Proprietary
Dimensions
12.8" x 16.5" (32.5cm x 41.9cm)
 
Processor/Cache
CPU
Dual 1366-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
Intel® Xeon®Processor 5600 Series (Westmere)
Intel® Xeon®Processor 5500 Series (Nehalem-EP)
 
QPI
up to 6.4 GT/s
 
System Memory
Memory Capacity
18x 240-pin DIMM slots
Supports up to 288GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
Supports up to 48GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
Memory Mirroring supported
 
Memory Type
1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs

 

DIMM Sizes
1GB, 2GB, 4GB , 8GB , 16GB

 

Memory Voltage
1.5 V / 1.35V

 

Error Detection
Corrects single-bit errors
Detects double-bit errors (using ECC memory)
Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
Note: This board does not support LRDIMM memory.
 
On-Board Devices
Chipset
Intel® 5520 (Tylersburg) chipset
ICH10R + IOH-36D

 

SAS
Broadcom 2108 SAS (6Gb/s) w/ Hardware RAID support; supports up to 16 devices
RAID 0, 1, 5, 6, 10, 50, 60 support
BBU (battery backup) extension kit (optional)
Onboard 512MB cache

 

SATA
Intel ICH10R SATA 3.0Gbps Controller
RAID 0, 1, 5, 10 support (Windows)
RAID 0, 1, 10 support (Linux)

 

IPMI
Support for Intelligent Platform Management Interface v.2.0
IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
Winbond® WPCM450 BMC

 

Network Controllers
Intel® 82576 Dual-Port Gigabit Ethernet Controller
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
Intel® I/OAT 3 support for fast, scaleable, and reliable networking
VMDq support for better performance of virtualization
1x Realtek RTL8201N PHY (dedicated IPMI)

 

Graphics
Matrox G200eW

 

Super I/O
Winbond 83827HF chip
 
Input / Output
SAS
8x 6Gb/s SAS / SATA ports with 2 I-PASS connectors
 
Serial ATA
Six Serial ATA ports
Six SATA hard drives supported
 
LAN
2x RJ45 LAN ports
1x RJ45 Dedicated IPMI LAN port
 
USB
2x USB rear ports
1x USB on-board
3x USB internal headers
Total 6 USB 2.0 Compliant
 
VGA
1x VGA Port
 
Keyboard / Mouse
PS/2 keyboard and mouse ports
 
Serial Port / Header
1 Fast UART 16550 serial port
1 Fast UART 16550 serial header
 
Chassis ( Optimized for X8DTU-6F+ )
Important Chassis Notes
To support the new generation Intel® Xeon® processor-based motherboards,
a Revision K chassis is recommended for most models. 
 
Expansion Slots
PCI-Express / PCI-X / UIO
Left Side
1 (x16) PCI-E 2.0 by riser card
Right Side
1 (x4) PCI-E 2.0 by riser card
 
For 2U configuration, Please go to UIO Riser Cards page
 
System BIOS
BIOS Type
32Mb SPI Flash EEPROM with AMI® BIOS
 
BIOS Features
Plug and Play (PnP)
PCI 2.2
ACPI up to 3.0
USB Keyboard support
 
Management
Software
IPMI (Intelligent Platform Management Interface) v1.5 / 2.0 with KVM support
SuperDoctor® III
 
Power Configurations
ACPI / ACPM Power Management
 
PC Health Monitoring
Voltage
Monitors for CPU Cores, +1.8V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby,
VBAT, Memory, Chipset Voltages.
6-Phase-switching voltage regulator
 
FAN
Total of eight fan headers supporting up to 8 fans
Eight 4-pin fan headers
8x fans with tachometer status monitoring
Support 3-pin fans (w/o speed control)
Low noise fan speed control (4-pin fan only)
 
Temperature
Monitoring for CPU and chassis environment
Thermal Control for 8x fan connectors
PECI
 
Other Features
Chassis intrusion detection
Chassis intrusion header
 
Operating Environment
Environmental Spec.
Operating Temperature: 10° to 35° C (50° to 95°F)
Non-operating Temperature: -40° to 70° C (-40° to 158° F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing)

 

Retour en haut
MBD-X8DTU-6F+
Notes et avis

Avis des internautes sur MBD-X8DTU-6F+ (0 avis)

pixel_trans
Il n'y a actuellement aucun avis pour cet article, soyez le premier à donner le votre.
pixel_trans
pixel_trans
[Ajouter votre commentaire]
Retour en haut