|
Physical Stats
Form Factor
Proprietary WIO
Dimensions
12.8" x 16.5" (32.5cm x 41.9cm)
Processor/Cache
CPU
Dual Socket R (LGA 2011), Intel® Xeon® processor E5-2600 and E5-2600 v2 family†
(up to 135W TDP **)
Note † BIOS version 3.0 or above is required
Note ** Motherboard supports this maximum TDP. Please verify your system can thermally support.
Cache
Up to 30MB
System Bus
QPI up to 8 GT/s
System Memory
Memory Capacity
24x 240-pin DDR3 DIMM slots
Up to 1.5TB DDR3 ECC LRDIMM
Up to 768GB DDR3 ECC RDIMM
Up to 128GB DDR3 ECC/non-ECC UDIMM
Memory Type
1866/1600/1333/1066/800MHz* ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
Support ECC and non-ECC UDIMMs
* Maximum memory speed may be capped by CPU. Please verify that the chosen CPU can support desired memory speed.
DIMM Sizes
32GB, 16GB, 8GB, 4GB, 2GB, 1GB, 64GB LRDIMM
Memory Voltage
1.5 V, 1.35 V
Error Detection
Corrects single-bit errors
Detects double-bit errors (using ECC memory)
On-Board Devices
Chipset
Intel® C606 chipset
SATA
SATA 2.0 3Gb/s with RAID 0, 1, 5, 10
SATA 3.0 6Gb/s with RAID 0, 1, 5, 10
SAS
SAS from C606
RAID 0, 1, 10 support
IPMI
Support for Intelligent Platform Management Interface v.2.0
IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
Nuvoton WPCM450 BMC
Network Controllers
Intel® i350 Gigabit Ethernet (x4 ports)
Virtual Machine Device Queues reduce I/O overhead
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
1x Realtek RTL8201N PHY (dedicated IPMI)
(Both CPUs need to be installed for LAN ports 3 and 4 to be enabled)
Video
Matrox G200eW
Input / Output
SATA
2 SATA 3.0 ports (6Gb/s)
4 SATA 2.0 ports (3Gb/s)
SAS
8 SAS ports
LAN
4 RJ45 Gigabit Ethernet LAN ports
1 RJ45 Dedicated IPMI LAN port
USB
7 USB 2.0 ports total
(2 rear + 4 via header + 1 Type A)
Video
1 VGA port
Serial Port / Header
2 Fast UART 16550 ports: 1 rear and 1 header
DOM
1 DOM (Disk on Module) power connector
TPM
1 TPM Header
|
|
Chassis (Optimized for X9DRW-3LN4F+)
1U Chassis
CSE-119TQ-R700WB
CSE-819TQ-R700WB
2U Chassis
CSE-219A-R920WB
CSE-829BTQ-R920WB
CSE-829TQ-R920WB
Important Chassis Notes
To support the new generation Intel® Xeon® processor-based motherboards,
Revision M chassis is recommended.
SuperServer(s) with X9DRW-3LN4F+
Model(s)
SYS-2027R-N3RF4+
SYS-1027R-WRF4+
SYS-6017R-N3RF4+
SYS-6027R-N3RF4+
Expansion Slots
PCI-Express
1 PCI-E 3.0 (x48) left hand side riser card support
(Both CPUs need to be installed for full access to PCI-E slots and onboard controllers.
See manual block diagram for details.)
System BIOS
BIOS Type
128Mb SPI Flash EEPROM with AMI BIOS
BIOS Features
Plug and Play (PnP)
APM 1.2
PCI 2.3
ACPI 1.0 / 2.0 / 3.0 / 4.0
USB Keyboard support
SMBIOS 2.7.1
UEFI 2.3.1
Management
Software
SuperDoctor® III
Watch Dog
NMI
IPMI 1.5 / 2.0
Power Configurations
ACPI / APM Power Management
Power-on mode for AC power recovery
PC Health Monitoring
Voltage
Monitors for CPU Cores, +1.1V, +1.5V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby,
VBAT, Memory Voltages.
5+1 Phase-switching voltage regulator
FAN
6x 4-pin fan headers (up to 6 fans)
6x fans with tachometer monitoring
Status monitor for speed control
Pulse Width Modulated (PWM) fan connectors
Temperature
Monitoring for CPU and chassis environment
CPU thermal trip support
Thermal Control for 8x Fan Connectors
Thermal Monitor 2 (TM2) support
PECI
LED
CPU / System Overheat LED
Suspend static indicator LED
UID/Remote UID
Other Features
Chassis intrusion detection
Chassis intrusion header
SDDC Support
RoHS
Operating Environment
Operating Temperature Range
10°C - 35°C (50°F - 95°F)
Non-Operating Temperature Range
-40°C - 70°C (-40°F - 158°F)
Operating Relative Humidity Range
8% - 90% (non-condensing)
Non-Operating Relative Humidity Range
5% - 95% (non-condensing)
|
