Physical Stats
Form Factor
MicroATX (uATX)
Dimensions
9.6" width x 9.6 " length , (24.4cm x 24.4cm), 6 layers
Processor/Cache
CPU
Single LGA775 ZIF Socket
Supports Quad-Core Intel® Xeon® X3300/X3200 series
Supports Dual-Core Intel® Xeon® E3100/3000 series
Supports Intel® Xeon® processor L3360 and L3110 series
Supports Intel® Core™2 Quad Q9000/Q8000/Q6000 series
Supports Intel® Core™2 Duo E8000/E7000/E6000/E4000 series
Supports Intel® Pentium® E5000/E2000 series
Supports Intel® Celeron® E1000 and 400 series
NOTE: Intel Xeon processor L3014 requires an LGA771 socket and is not supported.
System Bus
1333 / 1066 / 800 MHz system bus
System Memory
Memory Capacity
Four 240-pin DIMM sockets
Supports up to 8 GB of unbuffered ECC / non-ECC DDR2 800/667MHz memory (Dual Channel)
Memory Type
DDR2 800/667MHz unbuffered ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs
DIMM Sizes
256 MB, 512 MB, 1 GB, 2GB
Memory Voltage
1.8V only
On-Board Devices
Chipset
Intel® 3200 chipset
ICH9R chipset
Serial ATA
Intel® ICH9R SATA2 (3 Gbps) controller built-in
RAID 0, 1, 5, 10 support (Windows Only)
RAID 0, 1, 10 support (Linux)
Network Controllers
1x Intel® 82573V Gigabit PCI-Express Ethernet
Supports 10Base-T, 100Base-TX, 1000BASE-TX, RJ45 output
VGA
On-board XGI Volari Z9S 32MB graphics
Super I/O
Winbond 83627HG chip
Clock Generator
CK505
Input / Output
Serial ATA
Six Serial ATA ports (3 Gbps performance)
Six SATA hard drives supported
Floppy
1 Floppy controller; 1.44 MB
LAN
1 x RJ45 LAN port
USB
7x USB 2.0 / 1.1 compatible
2 rear + 2 headers ( 2 ports ) + 1 on-board
VGA
1x VGA Port
Keyboard / Mouse
PS/2 keyboard and mouse ports
Serial Ports
1x Fast UART 16550 serial port
1x Header
|
|
Chassis ( Optimized for X7SBL-LN1 )
Mid-Tower
CSE-733E-465B
CSE-733i-465B
CSE-733T-465B
CSE-733TQ-465B
Tower / 4U Rackmount
CSE-743TQ-865B
Important Note
To ensure system stability, a 300W (minimum) ATX power supply [4-pin +12V AND (20 or 24-pin)] is recommended.
Expansion Slots
PCI-Express
1 (x8) PCI-E slot
1 (x4) PCI-E (using x8) slot
PCI
2x 32-bit 33MHz PCI (5V) slot
System BIOS
BIOS Type
8Mb Flash EEPROM with Phoenix BIOS®
BIOS Features
Plug and Play (PnP)
DMI 2.3 support
PCI 2.2
ACPI 1.0/2.0
USB Keyboard support
SMBIOS 2.3
Management
Software
SuperDoctor® III
Watch Dog
NMI
W83793 H/W Monitor
Power Configurations
ACPI/APM Power Management
Main Switch Override Mechanism
Wake-On-Ring (WOR) header
Wake-On-LAN (WOL) header
Keyboard Wakeup from Soft-Off
Power-on mode control for AC power loss recovery
Internal / External Modem Rign-on
Suspend to RAM (STR)
PC Health Monitoring
Voltage
Monitors for CPU Cores +1.8V, +3.3V, +5V, ±12V, 3.3V Standby, 5V Standby, VBAT
CPU 4-Phase-switching voltage regulator with auto-sense from 0.8375V-1.6000V
Adjustable CPU clock frequency ratio (Only available if CPU is supported)
FAN
Total of six 4-pin fan headers
6 fans with tachometer monitoring
Status monitor with firmware speed control
Low noise fan speed control
Status monitor for on/off control
Support 3-pin fans (without speed control)
Pulse Width Modulated (PWM) fan connector
Temperature
Monitoring for CPU and chassis environment
CPU thermal trip support
Thermal Monitor 2 (TM2) support
PECI
LED
CPU / System Overheat LED
Suspend state indicator LED
Standby Power alert LED
Other Features
Chassis Intrusion Detection
Chassis Intrusion Header
Operating Environment
Environmental Spec.
Operating Temperature: 10°to 35°C (50°to 95°F)
Non-operating Temperature: -40°to 70°C (-40°to 158°F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing)
|